End-To-End Splice
 

Does anyone know of anybody who could do a constant diameter end-to-end splice on my continuous line furler? I wanted to replace the furling line when I had my boat set up and launched at Fay’s Boat Yard this week., but the riggers there were not familiar with doing this type of splice. I’d prefer to have it done on the boat rather than have to take the line somewhere, since that would require disconnecting my forestay again to install it back on the furler.

If not, here's a demo to do it yourself.

<iframe width="480" height="390" src="http://www.youtube.com/embed/fpyhS7WEWSE" frameborder="0" allowfullscreen></iframe>