Winnipesaukee Forum - View Single Post - Adding additional cleats to a V hull

robmac · 09-07-2011, 07:48 AM

I would also recommend putting tape on the surface then mark hole locations and drill. It will help the bit from sliding and the gel coat from popping as you drill. As far as access see if the cushions come out you may be able to reach from there.

09-07-2011, 07:48 AM	#10
robmac Senior Member Join Date: Jan 2005 Location: Nashua,Meredith Posts: 951 Thanks: 213 Thanked 106 Times in 81 Posts	I would also recommend putting tape on the surface then mark hole locations and drill. It will help the bit from sliding and the gel coat from popping as you drill. As far as access see if the cushions come out you may be able to reach from there.

The Following User Says Thank You to robmac For This Useful Post: