yanked it on Friday evening, let drain, got underneath it, found most of the rivets dripping, also pulled the floor and found that someone used 2inch plant foam (like the stuff that you poke the stems in and retains water) was used as ballast foam. Must have removed water wait of close to 60lbs, and I ended up replacing that with 2 inch closed cell water and mold resistant foam insulation found at any home depot type stores. coated all exposed rivets from the inside and even the ones under the fishing decks, went underneath and did the same thing. Let sit for over 24 hours launch it fished for 4 hours, put it on the mooring, waited over 9 hours......still taking in water but only pumped for about 20 seconds.
used capt. tolleys from the top, and then also lifelock on the bottom
Think I will pull it and have someone weld the rivets, would that be a problem? I would not think so
__________________
Capt. of the "No Worries"
|