Quote:
Originally Posted by aquabones
does anyone have insight on mounting a trolling motor (specifically a Minn Kota with a quick release mount) on the bow of a pontoon? i am trying to figure out where to place the battery and how to run the wires.the bow door does not have a cut out.
TIA
|
I had pretty much this exact setup years ago. You will need a door with a cut out or you can leave the door open.
As far as batteries go, I had mine in a cooler on wheels with an outlet built in the side so I could take it in and off the boat. My Minn Kota was a 36 volt so it required 3 batteries. I didn’t like the added weight of three batteries in the front when cruising so would only roll it on when fishing. If you want to permanently mount them, under the front seat is the best place. Make sure you are using the proper gauge wire and fuse as your Minn Kota draws a LOT of amperage..
See pics below….
Good luck!
Dan