View Single Post
Old 12-22-2025, 12:46 PM   #2
DickR
Senior Member
 
Join Date: Apr 2008
Location: Moultonborough
Posts: 768
Thanks: 4
Thanked 261 Times in 173 Posts
Default

Although my own dock is crank-up, I've helped monitor/adjust a neighbor's bubbler, and I oversee a friend's bubbler operation elsewhere through the winter. In both cases, the "bubbler" (aka "circulator") is the typical configuration of electric motor with a propeller, which produces an upward and inward flow of water during an operating interval. A timer, digital or mechanical, provides selection of multiple ON intervals and the duration of each.

An operating strategy that works well in one location may not work well in another, particularly when exposed to a lot of wind over a huge expanse of ice. In any case, when spring brings melting of the ice pack at the shorelines and the pack becomes mobile, wind can move the pack, however slowly, faster than a bubbler can melt it. Spring typically is when most dock damage is suffered, and that's up to Mother Nature.

I think it's better to have more short ON times than a few very long ON times. Once the upflow of water has taken out any ice formed since the last interval ended, continued operation accomplishes nothing. One thing a long ON interval does do is set a larger mass of water in motion, and when that inward flow reaches the shoreline it flows laterally, in some cases melting out the ice all the way across a neighbor's property, preventing his access to the ice. Furthermore, it's arguably better to have the the ice pack anchored to the shore on either side of the dock, to help retard movement of the ice pack when the wind blows.

Sources can be found that give expected ice formation rate vs. air temperature. Keeping any ice at all from forming around a dock when the bubbler is not running is not really needed. A very thin layer of ice doesn't have an awful lot of strength to it, and a bubbler doesn't need much time to remove such a thin layer. Some timers, like the old favorite Intermatic, allow intervals in 15-minute increments. Others provide 30-minute increments, one of which I think is sufficient in most situations. One such interval every three or four hours means a 2.5 or 3.5 hour interval of OFF time between ON times, and that's not an awful lot of time for ice formation.

In the case of a multi-dock installation protected by two or more bubblers, the schedule of ON intervals can be staggered across the bubblers, so that the area served by one bubbler can be partially served by the flow from another.

I'm sure others will have their own thoughts on this. It's a hot topic during the winter, as there are too many installations where bubblers run far too long, with little oversight, to the dismay of abutters.
DickR is offline   Reply With Quote