Winnipesaukee Forum - View Single Post

chipj29 · 05-04-2008, 01:28 PM

Make sure you measure the ID (Inside Diameter) of the hub very carefully. It is important for the bearing cap or bearing buddy to fit in there very tightly. They are often difficult to get on, since they are so tight.

05-04-2008, 01:28 PM	#5
chipj29 Senior Member Join Date: Apr 2004 Location: Bow Posts: 1,874 Thanks: 521 Thanked 308 Times in 162 Posts	Make sure you measure the ID (Inside Diameter) of the hub very carefully. It is important for the bearing cap or bearing buddy to fit in there very tightly. They are often difficult to get on, since they are so tight.