Bad Sea Doo Day

beantownbaby · 09-08-2016, 09:58 PM

Our 2016 sea doo quit and then sank. Thankfully NOT in 200 ft. Deep water, only in a channel. After analysis it turns out to be a resonator that over heated and melted a hole in the exhaust area. The mechanic can not find a cause, no clogged intake etc. my question is, does anyone have a similar experience or suggestion for how I trust this won't happen again if I were to pull in something unseen just below the surface? How can they build this machine with low level melt able parts in areas that are at risk of high heat?!! Thanks for any suggestions.

09-08-2016, 09:58 PM	#1
beantownbaby Member Join Date: Mar 2015 Posts: 41 Thanks: 153 Thanked 10 Times in 5 Posts	Bad Sea Doo Day Our 2016 sea doo quit and then sank. Thankfully NOT in 200 ft. Deep water, only in a channel. After analysis it turns out to be a resonator that over heated and melted a hole in the exhaust area. The mechanic can not find a cause, no clogged intake etc. my question is, does anyone have a similar experience or suggestion for how I trust this won't happen again if I were to pull in something unseen just below the surface? How can they build this machine with low level melt able parts in areas that are at risk of high heat?!! Thanks for any suggestions.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode